Removal Procedure
Important: Perform the
Crankshaft Position System Variation Learn
whenever the crankshaft position sensor is removed or replaced.
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Reposition the engine wiring harness sleeve (2).
- Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
- Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
- Remove the CKP sensor bolt.
- Remove the CKP sensor.
Installation Procedure
- Install the CKP sensor.
Notice: Refer to Fastener Notice in the Preface section.
- Install the CKP sensor bolt.
Tighten
Tighten the bolt to 25 N·m (18 lb ft).
- Connect the engine wiring harness electrical connector (1) to the CKP sensor.
- Position the engine wiring harness sleeve (2) over the CKP sensor electrical connection.
- Lower the vehicle.
- Perform the CKP system variation learn procedure. Refer to
Crankshaft Position System Variation Learn
.