GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Tahoe - 4WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Rear Wheel Speed Sensor Replacement

Removal Procedure

    Object Number: 924313 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Disconnect the electrical connector.
  3. Remove the wheel speed sensor retaining bolt.
  4. Release the wheel speed sensor wiring harness from the retainers.
  5. Remove the wheel speed sensor.

Installation Procedure

    Object Number: 924313 Size: SH
  1. Using a twisting motion, install the wheel speed sensor until fully seated.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the wheel speed sensor retaining bolt.

    3. Tighten
    Tighten the wheel speed sensor retaining bolt to 13 N·m (115 lb in).

  3. Connect the electrical connector.
  4. Install the wheel speed sensor wiring harness to the retainers.
  5. Lower the vehicle.
  6. Perform the Diagnostic System Check - Vehicle.