GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Tahoe - 4WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Radio Antenna Module Replacement

Object Number: 1697393 Size: MF

Callout

Component Name

Preliminary Procedure

  1. Remove the right lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement .
  2. Remove the screw from the HVAC duct and reposition the duct away from the module to allow access.
  3. Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side .

1

Radio Antenna Module Bolt

Notice: Refer to Fastener Notice in the Preface section.

Tighten
9 N·m (80 lb in)

2

Radio Antenna Ground Strap Screw

Tighten
2 N·m (18 lb in)

3

Radio Antenna Module

Tip

    • Slide the module up to release module retainers from the key slot.
    • Disconnect the electrical connectors.
    • Disconnect the antenna leads to the window.
    • Use a small flat-bladed screw driver or pick tool to release the plastic retaining tab tongue on cable. The retaining clip is not removable after glass installation, caution must be used to ensure it is not broken.