Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the front differential carrier shield, if equipped. Refer to
Shield Replacement
.
- Disconnect the electrical connector from the actuator.
- Remove the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.5 inch axle (4) by turning the
actuator counterclockwise.
Installation Procedure
- Apply sealant to the threads of the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.25 inch axle (4).
Use the correct sealant. Refer to
Adhesives, Fluids, Lubricants, and Sealers
.
Notice: Refer to Fastener Notice in the Preface section.
- Install the actuator (1 or 3).
Tighten
Tighten the actuator to 20 N·m (15 lb ft).
- Connect the electrical connector to the actuator.
- Install the front differential carrier shield, if equipped. Refer to
Shield Replacement
.
- Lower the vehicle.