• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provide an overview of each diagnostic category. |
• | Ignition ON. |
• | Ignition voltage is greater than 10 volts. |
The EBCM has detected an internal calabration failure.
• | The EBCM disables the antilock brake system (ABS), traction control, StabiliTrak are disabled for the duration of the ignition cycle. |
• | A DIC message and/or a warning indicator may be displayed. |
• | The condition for the DTC is no longer present. |
• | The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles. |
Antilock Brake System Schematics
Control Module References for scan tool information
Verify DTC C056E is not set.
⇒ | If DTC is set, replace the EBCM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programing