Callout
| Component Name
|
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM
with the ignition switch in the OFF position. Failure to observe this precaution
could result in damage to the EBCM/EBTCM.
Preliminary Procedures
- Turn the ignition switch to the OFF position.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove any dirt and debris from the area of the brake pressure modulator valve (BPMV)/electronic brake control module (EBCM) assembly.
|
1
| EBCM Screw (Qty: 4)
Notice: Refer to Fastener Notice in the Preface section.
Procedure
- Discard the EBCM screws.
- Install new EBCM screws.
- Tighten the EBCM screws in an X pattern.
Tighten 3 N·m (27 lb in) |
2
| Electronic Brake Control Module (EBCM)
Procedure
- Disconnect the EBCM electrical connector.
- Carefully pull the EBCM away from the BPMV. Do not force the components apart.
- Remove the EBCM to BPMV gasket and inspect for damage. Replace the gasket if necessary.
- Carefully align the EBCM and the brake pressure switch to the BPMV. Do not force the components together.
- After the installation is complete, program the EBCM. Refer to
Control Module References.
|