For 1990-2009 cars only
Removal Procedure
- Apply the park brake.
- Shift the transmission into neutral.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the retainer that secures the cable to the bracket.
- Depress the tangs and remove the cable from the bracket.
- Remove the bolts (1) securing the transmission range selector cable bracket (2) to the transmission.
- Remove the transmission range selector cable bracket.
Installation Procedure
- Install the transmission range selector cable bracket.
- Install the transmission range selector cable bracket bolts (1).
- Align and install the cable to the bracket.
- Install the retainer that secures the cable to the bracket.
- Lower the vehicle.
- Check the vehicle for proper operation. If cable adjustment is necessary, refer to Range Selector Lever Cable Adjustment .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
