Video Display Replacement. Chevrolet Tahoe

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Tahoe - 4WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Video Display Replacement

Video Display Replacement Second Row

Callout	Component Name
1	Video Display Assembly Screw (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tip Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded. Tighten 2 N·m (18 lb in)
2	Video Display Assembly Tip Pull down to disengage the retainer clip and remove from the vehicle. Disconnect the electrical connector.

Callout

Component Name

Video Display Assembly Screw (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tip
Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded.

Tighten
2 N·m (18 lb in)

Video Display Assembly

Tip

Pull down to disengage the retainer clip and remove from the vehicle.
Disconnect the electrical connector.

Video Display Replacement Third Row

Callout	Component Name
1	Video Display Assembly Screw (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 2 N·m (18 lb in) Tip Make sure that all 4 washers on the 4 mounting screws are accounted for. If any washers are off the screw and loose, discard to prevent a rattle. The washers were required only for assembly plant installation, and can be used if still on the screw or they can be discarded.
2	Video Display Assembly Tip Pull down to disengage the retainer clip and remove from the vehicle. Disconnect the electrical connector.