Did you review the Instrument Cluster Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Instrument Panel, Gages and Console

Verify that the oil gage indicator is inoperative.

Does the oil gage indicator operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Disconnect the oil pressure switch connector.
2. Connect a J 36169-A fused jumper from the oil pressure switch connector to chassis ground.

Does the oil pressure indicator light?

Go to Step 4

Go to Step 5

Replace the oil pressure switch.

Did you complete the repair?

Go to Step 8

--

1. Disconnect the instrument panel cluster assembly connector C2.
2. Test for a short to ground or open condition.
3. Test the YEL/BLK wire from cavity 3 to the oil pressure switch.

Is a short to ground or open condition present?

Go to Step 6

Go to Step 7

Repair the open in the YEL/BLK wire between the instrument panel cluster assembly and the oil pressure switch. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 8

--

Repair or replace the instrument panel cluster printed circuit. Refer to Printed Instrument Cluster Circuit Replacement .

Is the repair complete?

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3