GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 41409 Body Molding Removal Tool

Removal Procedure


    Object Number: 479570  Size: MH
  1. The front side door molding (2) is attached to the door with adhesive tape. Apply masking tape to the body side border of the molding to protect the body from scratches. The tape will also aid in aligning the front door molding (2) to the fender (3) and rear side door moldings (1) during installation.
  2. Important: Do not overheat the component.

  3. If the vehicle body is below 21°C (70°F) due to the shop temperature or the outside temperature, use a auxiliary heat source in order to warm the fender and molding before proceeding to the next step.
  4. Use J 41409 or the equivalent in order to cut through the adhesive material.
  5. Remove the molding (2) from the vehicle.

Installation Procedure


    Object Number: 479570  Size: MH
  1. Clean the front side door where the molding (2) is to be mounted.
  2. Use a suitable solvent, such as a mixture of 50 percent isopropyl alcohol and 50 percent water, or equivalent.
  3. Dry the area thoroughly.
  4. Important: Apply the adhesive tape in an environment free of dust or dirt so that it does not come in contact with the sticky backing and prevent proper adhesion.

  5. Install adhesive tape to the molding (2).
  6. If the vehicle body is below 21°C (70°F) due to the shop temperature or the outside temperature, use a auxiliary heat source in order to warm the front side door before proceeding to the next step.
  7. Remove the adhesive tape release sheet.
  8. Apply the molding (2) to the front side door using the masking tape as a guide.
  9. Apply an equal amount of pressure along the molding (2) to uniformly bond the molding to the front side door.