Removal Procedure
- Open the instrument panel
(IP) compartment.
- Push in the left and right side of the IP compartment and lower
the IP compartment.
- Unsnap the A/C compressor
control module (2) and slide towards the rear of the vehicle.
- Tilt the A/C compressor control module and disconnect the evaporator
temperature sensor connector.
- Disconnect the A/C compressor control module connector.
- Remove the A/C compressor control module from the vehicle.
Installation Procedure
- Install the A/C comparison
control module (2) to the vehicle.
- Connect the A/C comparison control module electrical connector.
- Tilt the A/C compressor control module and connect the evaporator
temperature sensor.
- Line up the A/C comparison control module with the slots on the
heater case and slide into place. Ensure that the A/C comparison control
module snaps into place.
- Close the instrument panel compartment.