GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Tracker - 4WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Endgate Lower Hinge Replacement

Removal Procedure

    Object Number: 473511 Size: SH
  1. Remove the right tail lamp.
  2. Remove the 4 bolts (1) that retain the endgate lower hinge (2) to the endgate panel.
  3. Remove the 3 bolts (3) that retain the endgate lower hinge (2) to the door jamb.
  4. Remove the endgate lower hinge (2) from the vehicle.

Installation Procedure

    Object Number: 473511 Size: SH
  1. Install the endgate lower hinge (2) to the vehicle. Secure the hinge to the door jamb with the 3 mounting bolts (3). Do not tighten completely at this time.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 4 bolts (1) that retain the endgate lower hinge (2) to the endgate panel.

    3. Tighten
    Tighten the endgate lower hinge mounting bolts to 34 N·m (25 lb ft).

  3. Install the right tail lamp.