- Lubricate the following with clean engine oil.
- Install the oil pump outer and inner gears to the oil pump body.
- Fill the oil pump with petroleum jelly to prime the oil pump.
- Install the relief valve (3), the spring (2) and the retainer (1).
- Install the oil pump cover to the oil pump body. Secure the cover with 5 bolts.
| • | The oil pump inner gear |
| • | The oil pump outer gear |
| • | The inside surface of the oil pump body |
Notice: Fill oil pump cavities with petroleum jelly prior to installation. This will ensure that there is oil pressure immediately on start-up and will prevent engine damage.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the retainer to 29 N·m (21 lb ft).
Tighten
Tighten the bolts to 12 N·m (9 lb ft).
