GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2004 🢒 Tracker - 4WD 🢒 Engine 🢒 Engine Controls - 2.5L (LE8) 🢒 Front Suspension Support Brace Replacement

Removal Procedure
  1. Partially raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information. Allow the suspension to hang free.

    2. Object Number: 464626 Size: SH
  2. Remove the 3 bolts (1) and the front suspension support brace (2) from the left side of the vehicle.
  3. Remove the 3 bolts and the brace from the right side of the vehicle.

Installation Procedure

    Object Number: 464626 Size: SH

    Important: Do not tighten the bolts.

  1. Install the front suspension support brace (2) and the 3 bolts (1) to the right side of the vehicle.

    2. Important: Do not tighten the bolts.

  2. Install the brace and the 3 bolts to the left side of the vehicle.

    3. If necessary, use a pry bar in order to align the bolt holes.

    Notice: Refer to Fastener Notice in the Preface section.

  3. Tighten the 6 bolts.

    4. Tighten
    Tighten the bolts to 50 N·m (36.5 lb ft).

  4. Lower the vehicle.