Removal Procedure
- Lift up on the front edge of the switch panel in order to release the front retaining clip.
- Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.
- If equipped, disconnect the electrical connectors from the passenger door module (1).
- If replacing only the passenger door module, remove the module from the door trim panel.
- Disconnect the remaining electrical connectors from the switch panel.
- If replacing only the switch panel, retain the passenger door module for transfer.
- Remove the switch panel assembly from the vehicle.
Installation Procedure
- Install the passenger door module (1) to the door trim panel.
- Connect the electrical connector to the passenger door module.
- If replacing the switch panel, connect the remaining electrical connectors.
Important: When replacing the passenger door module, the set up procedure must be performed.
- If replacing the passenger door module, program the passenger door module. Refer to
Control Module References for programming and setup information.
- Install the switch panel to the door trim panel, ensuring the front and rear retaining clips are fully seated.