GM Service Manual Online
For 1990-2009 cars only

Rear License Plate Pocket Replacement Envoy XUV

Removal Procedure


    Object Number: 1204240  Size: SH
  1. Swing open the endgate.
  2. Remove the endgate trim panel. Refer to Endgate Trim Panel Replacement .
  3. Remove the inner panel reinforcement. Refer to Endgate Inner Panel Reinforcement Replacement .
  4. Remove the endgate lock cylinder. Refer to Endgate Lock Cylinder Replacement .
  5. Disconnect the electrical connector (2) from the swing function handle.
  6. Remove the license plate pocket wiring harness retainers from the endgate.
  7. Disconnect the main license plate pocket electrical connector (1).
  8. Remove the nuts retaining the license plate pocket to the endgate.
  9. Remove the license plate pocket from the endgate.

Installation Procedure


    Object Number: 1204240  Size: SH
  1. Install the license plate pocket to the endgate.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the nuts retaining the license plate pocket to the endgate.
  4. Tighten
    Tighten the license plate pocket nuts to 10 N·m (89 lb in).

  5. Connect the main license plate pocket electrical connector (1).
  6. Connect the electrical connector to the swing function handle (2).
  7. Install the license plate pocket wiring harness retainers to the endgate.
  8. Install the lock cylinder. Refer to Endgate Lock Cylinder Replacement .
  9. Install the inner reinforcement. Refer to Endgate Inner Panel Reinforcement Replacement .
  10. Install the endgate trim panel. Refer to Endgate Trim Panel Replacement .