Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Column/Ignition Lock Schematics Connector End View Reference: Steering Wheel and Column Connector End Views | |||
1 | Did you review the Steering Wheel and Column Operation and perform the necessary inspections? | Go to Step 2 | |
2 |
Were you able to turn the key to the OFF position and remove the key? | Go to Step 3 | |
3 | Verify the fault is present. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
4 |
Does the test lamp turn ON and OFF with each cycle? | Go to Step 12 | Go to Step 5 |
5 | Connect a test lamp between the ground circuit of the ignition lock cylinder control actuator and B+ voltage. Does the test lamp illuminate? | Go to Step 6 | Go to Step 8 |
6 |
Does the test lamp illuminate? | Go to Step 11 | Go to Step 7 |
7 | Connect a test lamp between battery positive circuit of the ignition lock cylinder control switch and a good ground. Does the test lamp illuminate? | Go to Step 10 | Go to Step 9 |
8 | Repair the open in the ground circuit of the ignition lock cylinder control actuator circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 15 | -- |
9 | Repair the open or short to ground of the ignition lock cylinder control switch battery positive voltage circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 15 | -- |
10 | Repair the open, short to ground, or short to voltage of the ignition lock cylinder control switch signal circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 15 | -- |
11 | Inspect for poor connections at the ignition lock cylinder control switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 15 | Go to Step 13 |
12 | Inspect for poor connections at the ignition lock cylinder control actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 15 | Go to Step 14 |
13 | Replace the ignition lock cylinder control switch. Refer to Automatic Transmission Shift Lock Control Actuator Replacement . Did you complete the replacement? | Go to Step 15 | -- |
14 | Replace the ignition lock cylinder control actuator. Refer to Steering Wheel Theft Deterrent Lock Replacement . Did you complete the replacement? | Go to Step 15 | -- |
15 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 4 |