GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 TrailBlazer - 2WD 🢒 Body 🢒 Interior Trim 🢒 Roof Console Replacement

Removal Procedure

    Object Number: 741617 Size: SH
  1. Remove the dome lamp lenses by gently prying the lenses from the console.
  2. Remove the 2 screws that retain the console to the roof panel.
  3. Release the front retaining tabs.
  4. Lower the console and disconnect the electrical connectors as needed.
  5. Remove the console from the vehicle
  6. If replacing the console, remove the garage door opener if equipped. Refer to Garage Door Opener Replacement .
  7. If replacing the console, remove the OnStar® microphone if equipped. Refer to Mobile Telephone Microphone Replacement .
  8. If replacing the console, remove the personal message player/recorder if equipped. Refer to Personal Message Player/Recorder Replacement .
  9. If replacing the console, remove the power sunroof switch if equipped. Refer to Sunroof Switch Replacement .
  10. If replacing the console, remove the noise cancellation microphone if equipped. Refer to Radio Volume Compensator Interior Noise Microphone Replacement .

Installation Procedure
  1. If replacing the console, install the noise cancellation microphone if equipped. Refer to Radio Volume Compensator Interior Noise Microphone Replacement .
  2. If replacing the console, install the power sunroof switch if equipped. Refer to Sunroof Switch Replacement .
  3. If replacing the console, install the personal message player/recorder if equipped. Refer to Personal Message Player/Recorder Replacement .
  4. If replacing the console, install the OnStar® microphone if equipped. Refer to Mobile Telephone Microphone Replacement .
  5. If replacing the console, install the garage door opener if equipped. Refer to Garage Door Opener Replacement .

    6. Object Number: 741617 Size: SH
  6. Position the console to the roof panel.
  7. Connect the electrical connectors as needed.
  8. Seat the front retaining tabs.

    9. Notice: Refer to Fastener Notice in the Preface section.

  9. Install the 2 screws retaining the console to the roof panel.

    10. Tighten
    Tighten the screws to 1.2 N·m (10 lb in).

  10. Install the dome lamp lenses.