GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Disconnect the wire cover from the upper mirror base.

  2. Object Number: 375840  Size: SH
  3. Use a flat-bladed tool in order to disconnect the electrical connector (1) from the mirror (2), if equipped.
  4. Using a TORX ® screwdriver, loosen the set screw that holds the mirror base to the windshield button.

  5. Object Number: 787028  Size: SH
  6. Slide the mirror upward off of the rearview mirror button (1).

Installation Procedure


    Object Number: 787028  Size: SH
  1. Slide the mirror (2) onto the support button (1).
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the set screw.
  4. Tighten
    Tighten the set screw to 2 N·m (18 lb in).

  5. Connect the wire cover to the upper mirror base.

  6. Object Number: 375840  Size: SH
  7. Connect the electrical connector (1), if equipped.
  8. Reposition the mirror.
  9. Refer to Control Module References for programming and setup information.