- Remove the transmission fluid baffle bolts/screws (807) and the transmission fluid baffle (803).
- Remove the lube fluid pipe retainer bolt/screw (806).
- Remove the lube fluid pipe retainer (805).
- Remove the lube fluid pipe (804).
- Inspect the torque converter housing for damage. If the bearings are faulty, the converter housing requires replacement.
- Using a plastic hammer, install the lube fluid pipe (804).
- Place the 3 chip collector magnets (808) onto the transmission fluid baffle (803).
- Install the transmission fluid baffle (803) and the 3 - M6 x 1.0 x 14 mm transmission fluid baffle bolts (807).
- Install the lube fluid pipe retainer (805) and the M6 x 1.0 x 14 mm lube fluid pipe retainer bolt (806) into the torque converter housing assembly.
Important: Do not bend or damage the lube fluid pipe (804).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 3 transmission fluid baffle bolts
to 5 N·m (44 lb in).
Tighten
Tighten the bolt to 5 N·m (44 lb in).
