Special Tools

1. Inspect the alignment mark between the differential bearing adjuster and the differential carrier assembly case. If the line between the differential bearing adjuster and the differential carrier assembly case is not aligned, re-align the 2 components as necessary.



2. Install the left side inner shaft seal using the J 45225  (2) and the J 8092  (1).



3. Install the right side inner shaft seal using the J 45225  (2) and the J 8092  (1).

Caution: Refer to Component Fastener Tightening Caution in the Preface section.

4. Install the drain plug and tighten to 32 N·m (24 lb ft).
5. Install the fill plug and tighten to 32 N·m (24 lb ft).