Tools Required

J 25070 Heat Gun

1. Install the rear case shift shaft bushing.
2. If S/T vehicle, install the retaining ring for the shift shaft bushing.



3. If 4WD vehicle, install the main shaft rear bearing in the rear case.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. If 4WD vehicle, install the main shaft bearing retainer and the bolts.

Tighten
Tighten the main shaft bearing retainer bolts to 22 N·m (16 lb in).




5. Using the J 25070 heat the rear housing countershaft bearing bore for 10 minutes.
6. Install the countershaft bearing race using a suitable bearing installer.