Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the connector position assurance (CPA) retainer.
- Disconnect the heated oxygen sensor (HO2S) electrical connector (1).
- Remove the HO2S (2).
Notice: Refer to Heated Oxygen and Oxygen Sensor Notice in the Preface section.
Notice: Refer to Excessive Force and Oxygen Sensor Notice in the Preface section.
Installation Procedure
- If reinstalling the old sensor, coat the threads with anti-seize compound GM P/N 12377953, or equivalent.
- Install the HO2S (2).
- Connect the HO2S electrical connector (1).
- Install the CPA retainer.
- Lower the vehicle.
Notice: Refer to Component Fastener Tightening Notice in the Preface section.
Important: A special anti-seize compound is used on the HO2S threads. The compound consists of liquid graphite and glass beads. The graphite tends to burn away, but the glass beads remain, making the sensor easier to remove. New, or service replacement sensors already have the compound applied to the threads. If the sensor is removed from an exhaust component and if for any reason the sensor is to be reinstalled, the threads must have anti-seize compound applied before the reinstallation.
Tighten
Tighten the sensor to 42 N·m (31 lb ft).
