Important: The fastener retaining the front latch to
the front latch slide is not reusable if the front lock assembly is replaced, a new
service rivet must be used during reassembly.
Using a small flat-bladed tool, push the
end of the front latch slide (3) forward until the front latch slide (1)
is protruding from the moveable roof frame assembly (2).
Remove the front latch slide (1) from the moveable roof frame assembly (2),
by sliding it forward out of the channel of the frame assembly.
Install the front latch slide (1)
to the moveable roof frame assembly channel (2).
Using a small flat-bladed tool, slide the front latch slide rearward until
the end (3) is protruding from the rear of the moveable roof frame assembly.