Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Disconnect the crankshaft position (CKP) sensor harness connector.
- Remove the CKP sensor retaining bolt.
- Remove the CKP sensor from the engine block.
Installation Procedure
Note: Inspect the sensor O-ring for the following conditions:
Replace the O-ring if necessary. Lubricate the new O-ring with engine oil before installation.
Caution: Refer to Fastener Caution in the Preface section.
- Install the CKP sensor into the engine block. Tighten the bolt to
10 N·m (89 lb in).
- Install the CKP sensor retaining bolt.
- Connect the CKP sensor harness connector.
- Lower the vehicle.
- Perform the
Crankshaft Position System Variation Learn.