GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the fuel tank shield, if equipped. Refer to Fuel Tank Shield Replacement.
  3. Remove the rear propeller Shaft. Refer to Rear Propeller Shaft Replacement.
  4. Drain the transfer case. Refer to Transfer Case Fluid Replacement.

  5. Object Number: 747098  Size: SH
  6. Remove the fuel lines from the retainer.

  7. Object Number: 747099  Size: SH
  8. Remove the electrical harness from the retainer (right side).

  9. Object Number: 747096  Size: SH
  10. Remove the electrical harness from the retainer (left side).

  11. Object Number: 746670  Size: SH
  12. Disconnect the electrical connectors from the speed sensors (front speed sensor shown).
  13. Disconnect the motor/encoder electrical connector.

  14. Object Number: 747103  Size: SH
  15. Remove the transfer case wiring harness.

  16. Object Number: 747097  Size: SH
  17. Disconnect the vent hose.
  18. Install a transmission jack for the transfer case.

  19. Object Number: 879658  Size: SH
  20. Remove the transfer case adapter (2) to transfer case nuts (5).
  21. Note: While removing the transfer case the front propeller shaft must be disconnected from the transfer case. Refer to Front Propeller Shaft Replacement.

  22. Remove the transfer case (3) from the vehicle.
  23. Note: The transfer case gasket may become damaged during the removal procedure.

  24. Remove the transfer case gasket (4).

Installation Procedure


    Object Number: 879658  Size: SH

    Note: If the transfer case gasket is damaged, replace it. DO NOT use silicone sealant in place or with the transfer case gasket.

    Note: While installing the transfer case the front propeller shaft must be connected to the transfer case. Refer to Front Propeller Shaft Replacement.

  1. Install or replace the transfer case gasket (4).
  2. Install the transfer case (3) in the vehicle.
  3. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the transfer case adapter (2) to transfer case nuts (5). Ensure the fuel line retainer (1) is in place.
  5. Tighten
    Tighten the nuts to 47 N·m (35 lb ft).

  6. Remove the transmission jack stand.

  7. Object Number: 746670  Size: SH
  8. Connect the electrical connectors to the speed sensors (front speed sensor shown).

  9. Object Number: 747097  Size: SH
  10. Connect the vent hose.
  11. Connect the motor/encoder electrical connector.

  12. Object Number: 747103  Size: SH
  13. Install the transfer case harness to the transfer case.

  14. Object Number: 747096  Size: SH
  15. Install the transfer case wiring harness to the retainers (left side).

  16. Object Number: 747099  Size: SH
  17. Install the transfer case wiring harness to the retainers (right side).

  18. Object Number: 747098  Size: SH
  19. Install the fuel lines to the retainer.
  20. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement.
  21. Fill the transfer case with fluid. Refer to Transfer Case Fluid Replacement.
  22. Install the fuel tank shield, if equipped. Refer to Fuel Tank Shield Replacement.
  23. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.