• | J 6125-1B Slide Hammer |
• | J 41818 Crankshaft Bearing Cap Remover |
For equivalent regional tools, refer to Special Tools
Note:
• The crankshaft bearing caps are machined with the engine block, for the proper clearances. Mark or identify each crankshaft bearing cap location and direction before removal. The crankshaft bearing caps MUST be installed to their original position
and direction. • Do not use the bearing cap M8 side bolts again.
Caution: Refer to Fastener Caution in the Preface section.
Note: Use care when handling the crankshaft. Avoid damage to the crankshaft position sensor reluctor ring teeth. Nicks, burrs or other damage to the teeth may effect on-board diagnostics (OBD) II system performance.