Removal Procedure
- Remove the harness connector.
- Remove the bolt (2).
- Remove the vehicle speed sensor (1).
- Remove the O-ring seal (3).
Installation Procedure
- Install the O-ring seal (3) on the vehicle speed sensor (1).
- Coat the O-ring seal (3) with a thin film of transmission fluid.
- Install the vehicle speed sensor (1) into the transmission case.
Caution: Refer to Fastener Caution in the Preface section.
- Install the bolt (2) and tighten to
11 N·m (97 lb in)
- Connect the wiring harness electrical connector to the vehicle speed sensor.
- Refill the fluid as required.