Tow/haul mode enables the operator to achieve enhanced shift performance when towing or hauling a load. When tow/haul mode is selected, the tow/haul switch input signal to the body control module (BCM) is momentarily toggled to zero volts. This signals the transmission control module (TCM) to extend the length of time between upshifts and increase transmission line pressure. Cycling the tow/haul switch again disables tow/haul mode and returns the transmission to a normal shift pattern. The tow/haul switch is a momentary switch and is normally open. The internal spring in the switch will always cause the switch state to return to open when not held in to the closed position.

If the electrical circuit checks are OK and the tow/haul shift pattern is not occurring, there may be a mechanical/hydraulic condition that prevents tow/haul operation. Refer to Symptoms - Automatic Transmission .

Schematic Reference

Automatic Transmission Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Transmission Control Module Scan Tool Information

With a scan tool observe the Tow/Haul switch parameter. Operate the Tow/Haul switch several times, and observe the parameter as you operate the switch with the transmission in DRIVE. The parameter should toggle between ACTIVE and INACTIVE when the switch is operated.

1. Ignition OFF, transmission in PARK or NEUTRAL, disconnect the Tow/Haul switch connector.
2. Test for less than 1 ohm of resistance between the Tow/Haul switch signal circuit terminal B and ground.

⇒	If greater than the specified range, test the ground circuit for an Open/High resistance.

3. Ignition ON, verify the scan tool parameter Park/Neutral displays INACTIVE.

⇒	If not the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the BCM.

4. Install a fused jumper between the signal circuit and ground. Verify the scan tool parameter displays ACTIVE.

⇒	If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

5. If all circuits test normal, replace the Tow/Haul switch.

1. Ignition OFF, transmission in PARK or NEUTRAL, disconnect the transmission Tow/Haul switch assembly.
2. Test for infinite resistance between the Tow/Haul switch with the switch in the OPEN position.

⇒	If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the Tow/Haul switch assembly.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.