Removal Procedure
- Remove the floor console. Refer to
Console Replacement.
- Rotate the console.
- Remove the screw from the air outlet duct.
- Remove the air outlet duct from the floor console.
- Remove the rear mode actuator retaining screws.
- Disconnect the electrical connector.
- Remove the rear mode actuator.
Installation Procedure
- Install the mode actuator.
- Connect the electrical connector.
Caution: Refer to Fastener Caution in the Preface section.
- Install the screws to the mode actuator.
Tighten
Tighten the screws to 1.9 N·m (17 lb in).
- Install the air outlet duct to the console.
- Install the screw to the air outlet duct.
Tighten
Tighten the screw to 1.9 N·m (17 lb in).
- Install the console. Refer to
Console Replacement.