Removal Procedure
- Remove the 2 screws that retain the insulator panel to the instrument panel (I/P).
- Partially remove the insulator panel.
- Remove the electrical connector retaining clip from the back side of the insulator panel, if equipped.
- Remove the insulator panel from the vehicle.
Installation Procedure
- Install the insulator panel to the vehicle, positioning the insulator panel to the I/P.
- Install the electrical connector retaining clip to the back side of the insulator panel, if equipped.
- Insert the insulator panel retaining tab into the cowl slot.
- Seat the insulator panel retaining clip to the I/P substrate.
Caution: Refer to Fastener Caution in the Preface section.
- Install the 2 insulator panel retaining screws and tighten to
2.5 N·m (22 lb in).