GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Traverse 🢒 Engine 🢒 Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Engine Rear Mount Bracket Replacement

Object Number: 2064447 Size: MF

Callout

Component Name

Preliminary Procedures

  1. If equipped with FWD, remove the intermediate drive shaft. Refer to Front Wheel Drive Intermediate Shaft Replacement.
  2. Support the engine. Refer to Engine Support Fixture.
  3. Remove the exhaust flexible pipe. Refer to Exhaust Flexible Pipe Replacement.

1

Rear Engine Mount Upper Nut

Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Remove and discard engine mount nut.
  2. Apply threadlocker to the engine mount threads. Refer to Adhesives, Fluids, Lubricants, and Sealers.

Tip

    • The engine mount nuts must be replaced once removed. Allow adhesive on new engine mounts nuts to cure for 24 hours after replacement.
    • Use engine support fixture to raise engine.

Tighten
50 N·m (37 lb ft)

2

Rear Engine Mount Bracket Bolt

Tighten
58 N·m (43 lb ft)

3

Rear Engine Mount Bracket Bolt

Tighten
22 N·m (16 lb ft)