GM Service Manual Online
For 1990-2009 cars only
Makes
馃
Chevrolet
馃
2009
馃
Traverse
馃
Engine
馃
Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L
馃 Transmission Mount Replacement - Left Side
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Remove the left engine splash shield. Refer to
Engine Splash Shield Replacement
.
Support the transmission with a transmission jack.
Remove the transmission mount nuts (1, 2).
Remove the transmission mount bracket bolts (1, 2).
Using the transmission jack, lift the transmission just enough to gain clearance for tilting the transmission mount.
Remove the transmission mount bracket bolt (3).
Remove the transmission mount (2) and bracket (1) from the vehicle.
Installation Procedure
Install the transmission mount (2) and bracket (1) to the vehicle.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the transmission mount bracket bolt (3) and tighten to
90 N路m (66 lb ft)
.
Install the transmission mount bracket bolt (1) and tighten to
90 N路m (66 lb ft)
.
Using the transmission jack, lower the transmission until the transmission mount bracket rests on the transmission mount.
Install the transmission mount bracket bolt (2) and tighten to
90 N路m (66 lb ft)
.
Remove the transmission jack.
Install the transmission mount nut (2) and tighten to
75 N路m (55 lb ft)
.
Install the transmission mount nut (1) and tighten to
90 N路m (66 lb ft)
.
Install the left engine splash shield. Refer to
Engine Splash Shield Replacement
.
Lower the vehicle