GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Traverse 🢒 Engine 🢒 Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Power Steering Fluid Reservoir Bracket Replacement

Removal Procedure
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  2. Remove the right side engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side
  3. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
  4. Place drain pans under the vehicle as needed.

    5. Object Number: 1856010 Size: SH
  5. Disconnect the power steering reservoir inlet hose (1).

    6. Object Number: 1856009 Size: SH
  6. Disconnect the power steering fluid reservoir outlet hose (1).

    7. Object Number: 2075295 Size: SH
  7. Remove the remote power steering fluid reservoir bracket bolts (1).
  8. Remove the remote power steering fluid reservoir bracket (2).
  9. Transfer any parts as needed.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 2075295 Size: SH
  1. Install the remote power steering fluid reservoir bracket (2).
  2. Install the remote power steering fluid reservoir bracket bolts (1) and tighten to 9 N·m (80 lb in).

    3. Object Number: 1856009 Size: SH
  3. Connect the power steering fluid reservoir outlet hose (1).

    4. Object Number: 1856010 Size: SH
  4. Connect the power steering reservoir inlet hose (1).
  5. Clean all excess fluid from the vehicle and remove the drain pans.
  6. Install the right side engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side
  7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding.
  8. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.