GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Uplander 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - 4T65-E 🢒 Transmission Mount Bracket Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation.
  3. Remove the left engine splash shield. Refer to Engine Splash Shield Replacement.
  4. Use a utility stand with a block of wood in order to support the transaxle.

    5. Object Number: 368791 Size: SH
  5. Remove the transaxle mount upper nuts.

    6. Object Number: 161246 Size: SH
  6. Remove the transaxle mount bracket bolts.
  7. Remove the transaxle mount bracket.

Installation Procedure
  1. Position the transaxle mount bracket.

    2. Object Number: 161246 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the transaxle mount bracket bolts.

    3. Tighten
    Start with the forward lower bolt and work clockwise to tighten the transaxle mount bracket bolts to 95 N·m (70 lb ft).

  3. Remove the utility stand.

    4. Object Number: 368791 Size: SH
  4. Install the transaxle mount upper nuts.

    5. Tighten
    Tighten the nuts to 47 N·m (35 lb ft).

  5. Install the left engine splash shield. Refer to Engine Splash Shield Replacement.
  6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation.
  7. Lower the vehicle.