Rear Side Door Locator Replacement Door Side

Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.

1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
2. Open the sliding door.



3. Remove the sliding door locating pin screws (3).
4. Remove the sliding door locating pin (2) from the vehicle (1).

1. Install the sliding door locating pin (2) to the sliding door (1).
2. Loosely install the sliding door locating pin screws (3), just tightly enough to retain the locating pin.
3. Close and then reopen the sliding door.

Notice: Refer to Fastener Notice in the Preface section.

4. Re-torque the locating pin screws to the sliding door.

Tighten
Tighten the sliding door locating pin screws to 10 N·m (89 lb in).

5. Close the sliding door.