Rear Wheel Bearing and Hub Replacement for Chevrolet Uplander 2009

Rear Wheel Bearing and Hub Replacement Without Independent Suspension

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Remove the brake caliper. Refer to Rear Brake Caliper Replacement .



4. Remove and DISCARD the wheel bearing/hub bolts.
5. Remove the wheel bearing/hub.
6. Disconnect the wheel speed sensor electrical connector.

1. Connect the wheel speed sensor electrical connector.
2. Install the wheel bearing/hub.

Caution: Refer to Fastener Caution in the Preface section.

Warning: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.

3. Install the NEW wheel bearing/hub bolts and tighten to 80 N·m (59 lb ft) .
4. Install the brake caliper. Refer to Rear Brake Caliper Replacement .
5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
6. Lower the vehicle.