GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Uplander 🢒 Body Repair 🢒 Bolted Exterior Body Panels and Closures 🢒 Rear Side Door Upper Roller Bracket Replacement

Removal Procedure
  1. Remove the sliding door garnish molding. Refer to Rear Side Door Garnish Molding Replacement .
  2. Remove the headliner trim finish molding. Refer to Headlining Trim Panel Molding Replacement .
  3. Support the sliding door.

    4. Object Number: 1480571 Size: SH
  4. Mark the location of the sliding door upper roller bracket (1) to the door (2) with a grease pencil.
  5. Remove the sliding door upper roller bracket bolts.

    6. Object Number: 319976 Size: SH
  6. Remove the sliding door upper roller bracket from the front edge of the upper track.

Installation Procedure

    Object Number: 319976 Size: SH
  1. Install the sliding door upper roller bracket to the front edge of the upper track.

    2. Object Number: 1480571 Size: SH
  2. Align the sliding door upper roller bracket (1) to the grease pencil marks.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the sliding door upper roller bracket bolts and tighten, in sequence as shown, to 10 N·m (89 lb in) .
  4. Remove the support from the sliding door.
  5. Adjust the sliding door, if needed. Refer to Sliding Rear Side Door Adjustment .
  6. Install the headliner trim finish molding. Refer to Headlining Trim Panel Molding Replacement .
  7. Install the sliding door garnish molding. Refer to Rear Side Door Garnish Molding Replacement .