Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Remove the oil filter. Refer to
Engine Oil and Oil Filter Replacement
.
- Remove the oil filter bypass hole plug.
Important: Do not remove the oil filter fitting unless replacement or repair is needed.
- Remove the oil filter fitting, if necessary.
Important: Do not pry against the threads in the oil filter bypass hole when removing the bypass valve.
- Insert a flat bladed tool into the oil filter bypass hole and remove the bypass valve.
Installation Procedure
- Install the oil filter bypass valve.
Notice: Refer to Fastener Notice in the Preface section.
- Install the oil filter fitting, if necessary.
Tighten
Tighten the oil filter fitting to 39 N·m (29 lb ft).
- Install the oil filter bypass valve plug. Apply sealer to the threads. Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the 3.5L engine.
Tighten
Tighten the oil filter bypass valve plug to 19 N·m (14 lb ft).
- Install the oil filter. Refer to
Engine Oil and Oil Filter Replacement
.
Tighten
Tighten the oil filter to 30 N·m (22 lb ft).
- Lower the vehicle.
- Check and fill the crankcase as necessary.