GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Important: When replacing battery cables, be sure to use replacement cables that are the same type, gage, and length.

  1. Disconnect the battery ground (negative) cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .

  2. Object Number: 1533512  Size: SH
  3. Disconnect the battery current sensor electrical connector (2).

  4. Object Number: 1544743  Size: SH
  5. Disconnect the battery positive cable (3) from the battery.
  6. Remove the battery ground negative cable nut from the inner fender (4).

  7. Object Number: 1544745  Size: SH
  8. Remove the battery positive cable nut (1) and cable (3) from the underhood electrical center.

  9. Object Number: 368798  Size: SH
  10. Remove the battery ground negative cable nut and cable from the transaxle stud.
  11. Remove the starter motor BAT terminal nut from the starter motor.
  12. Remove the battery positive cable from the starter motor BAT terminal.

  13. Object Number: 1544744  Size: SH
  14. Remove the battery cable conduit retainers from the inner fender (1) and the lower tie bar (2).
  15. Remove the battery ground negative and battery positive cables from the vehicle.
  16. Separate the battery ground negative and battery positive cables.
  17. Remove the battery current sensor if the negative battery cable is being replaced. Refer to Battery Current Sensor Replacement .

Installation Procedure

  1. Install the battery current sensor if previously removed or negative battery cable was replaced. Refer to Battery Current Sensor Replacement .

  2. Object Number: 1544744  Size: SH
  3. Install the battery ground (negative) and the battery positive cables to the vehicle.
  4. Install the battery cable conduit retainers to the inner fender (1) and the lower tie bar (2).

  5. Object Number: 368798  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the battery positive cable and nut to the starter motor BAT terminal.
  7. Tighten
    Tighten the starter motor BAT terminal nut to 10 N·m (89 lb in).

  8. Install the battery ground (negative) cable and nut to the transaxle stud.
  9. Tighten
    Tighten the battery ground (negative) cable nut to 25 N·m (18 lb ft).


    Object Number: 1544745  Size: SH
  10. Install the battery positive cable (3) and nut (1) to the underhood electrical center.
  11. Tighten
    Tighten the nut to 10 N·m (89 lb in).


    Object Number: 1544743  Size: SH
  12. Install the battery ground negative cable nut to the inner fender (4).
  13. Tighten
    Tighten the nut to 5 N·m (44 lb in).

  14. Connect the battery positive cable (3) from the battery.
  15. Tighten
    Tighten the battery terminal bolt to 16 N·m (12 lb ft).


    Object Number: 1533512  Size: SH
  16. Connect the battery current sensor electrical connector (2).
  17. Install the battery ground (negative) cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .