Tools Required

J 38778 Door Trim Pad Clip Remover

1. Use J 38778 in order to remove the push-in retainer from the lower rear bumper fascia splash shield.
2. Remove the rear bumper fascia splash shield screws from the rear bumper fascia splash shield.
3. Remove the rear bumper fascia splash shield from the rear bumper fascia.

1. Align the rear bumper fascia splash shield to the rear bumper fascia.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the rear bumper fascia splash shield screws to the rear bumper fascia splash shield.

Tighten
Tighten the rear bumper fascia splash shield screws to 2 N·m (18 lb in).

3. Install the push-in the retainer to the lower rear bumper fascia splash shield.