GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Uplander Ext. 🢒 Body 🢒 Exterior Trim 🢒 Roof Weld Joint Reveal Molding Replacement

Removal Procedure

    Object Number: 787182 Size: SH
  1. Open the side doors.
  2. Partially remove the weatherstrip from the roof drip rail, by pulling it from the flange.

    3. Notice: Refer to Exterior Trim Emblem Removal Notice in the Preface section.


    Object Number: 787183 Size: SH
  3. Remove the weld joint molding from the roof studs using a flat-bladed tool.

    4. Object Number: 787185 Size: SH
  4. Remove the weld joint molding from the roof.

    5. Object Number: 787188 Size: SH
  5. Remove the insulators from the weld joint molding, if necessary.

    6. Object Number: 787190 Size: SH
  6. Remove the weld joint molding retainers from the weld joint molding using a flat-bladed tool, if necessary.

Installation Procedure

    Object Number: 787192 Size: SH
  1. Install the weld joint molding retainers to the weld joint molding, pressing until fully seated.

    2. Object Number: 787188 Size: SH
  2. Install the insulators to the weld joint molding, if removed.

    3. Object Number: 787185 Size: SH
  3. Position the weld joint molding to the roof.

    4. Object Number: 787193 Size: SH
  4. Press the weld joint molding onto the roof studs, until fully seated.

    5. Object Number: 787182 Size: SH
  5. Install the weatherstrip to the roof drip rail.
  6. Press the weatherstrip onto the flange until fully seated.
  7. Close the side doors.