Tools Required
J 38778
Door Trim Pad Clip Remover
Removal Procedure
- Remove the upper seat belt anchor bolt from the belt guide loop.
- Remove the body pillar upper trim panel retainers using the
J 38778
.
- Remove the upper trim panel from the body pillar by pulling the panel from the locator tabs.
- Disconnect the speaker wire harness connector.
Installation Procedure
- Connect the speaker wire harness connector.
- Align the locator tabs on the upper trim panel with the rear quarter trim panel.
- Align the upper trim panel retainers with the holes and push to secure the panel to the vehicle.
- Align the slider door seal to the body pillar upper trim panel if applicable.
Notice: Refer to Fastener Notice in the Preface section.
- Install the upper seat belt anchor bolt to the belt guide loop.
Tighten
Tighten the bolt to 43 N·m (32 lb ft).