GM Service Manual Online
For 1990-2009 cars only

Torque Converter Replacement Guide

Condition

Action

Fluid

  • Transmission Fluid Oxidized/Discolored
    • No metal debris
    • Clutch fiber material

Do not replace the torque converter.

Refer to Transmission Fluid Check .

  • Transmission Fluid Contaminated with Engine Coolant/Oil

Replace the torque converter.

Refer to Torque Converter Cover Replacement .

  • Transmission Fluid Contaminated with Sludge/Metal Particles
    • Replace the torque converter if the following conditions are found:
       - Pump damage
       - Drive sprocket support damage
       - Turbine/stator shaft damage
       - No damage found in transmission
    • Do not replace the torque converter for other transmission component damage.
  • Fluid Leaks from Torque Converter
    • Perform the powder/dye leak check
        Refer to Fluid Leak Diagnosis .
    • Replace the torque converter if the following conditions are found:
       - Leak present at weld areas-hub, lug, or closure weld
       - Hub surface is damaged-scored, raised/transferred metal
       - Bushing is damaged

Function/Appearance

  • Torque Converter Discolored/Overheated

Replace the torque converter.

Refer to Torque Converter Cover Replacement .

  • Broken/Cracked Flexplate

Replace the torque converter.

Refer to Torque Converter Cover Replacement .

  • Stripped Converter Bolt Holes

Replace the torque converter.

Refer to Torque Converter Cover Replacement .

  • Torque Converter Pilot Damaged

Replace the torque converter.

Refer to Torque Converter Cover Replacement .

  • Torque Converter Ballooning

Replace the torque converter if end play exceeds 0.7mm (0.3 in) using J 35138 .

Driveability - Non TCC

  • Harsh Gear Shifts-Non TCC

Do not replace the torque converter.

Refer to Symptoms - Automatic Transmission .

  • No Drive/Slips in Drive-Non TCC

Do not replace the torque converter until completing all engine and transmission diagnostics.

Refer to Slips in Drive or No Drive .

  • Idle Surge/Rough Idle

Do not replace the torque converter.

Refer to Rough, Unstable, or Incorrect Idle and Stalling in Engine Controls-3.5L.

  • Poor Acceleration above 48 km/h (30 mph)-Launch

Do not replace the torque converter until completing all engine and transmission diagnostics.

    • Refer to Lack of Power, Sluggishness, or Sponginess in Engine Controls-3.5L.
    • Refer to Hesitation, Sag, Stumble in Engine Controls-3.5L.
    • Refer to Symptoms - Automatic Transmission .
  • DTC P0741-TCC Stuck OFF/High Slip-Intermittent Only

Do not replace the torque converter.

Refer to DTC P0741 .

  • DTC P0741-TCC Stuck OFF/High Slip

Refer to DTC P0741 .

  • DTC P0742-TCC Stuck ON

Do not replace the torque converter.

Refer to DTC P0742 .

  • DTC P1887-TCC Release Switch

Do not replace the torque converter.

Refer to DTC P1887 .

  • TCC Apply/Release Shudder

Refer to Converter Clutch Apply Rough, Slips, or Shudders .

  • TCC Chuggle
    • Refer to Symptoms - Engine Mechanical in Engine Mechanical-3.5L.
    • Refer to Surges/Chuggles in Engine Mechanical-3.5L.
    • Refer to Symptoms - Automatic Transmission .

Noise and Vibration

  • Noise-Whine
    • Refer to Symptoms - Automatic Transmission .
    • Do not replace the torque converter if noise is present in Neutral/Park. Refer to Symptoms - Engine Mechanical in Engine Mechanical-3.5L.
  • Vibration-Out of Balance
    • Refer to Vibration Analysis - Engine in Vibration Diagnosis and Correction.