- Inspect the park system components for the
following conditions:
• | A worn park pawl actuator guide (809) |
• | A damaged or bent park pawl actuator assembly (800) |
• | A damaged internal mode switch (IMS) detent lever (811) |
• | A bent or damaged manual valve link (402) |
• | A kinked or bent manual valve link spring (403) |
- Use
a 9/16 inch socket and a hammer in order to install the manual shift
shaft seal assembly (806) into the case.
- Install
a new park pawl actuator guide O-ring seal (810) onto the park pawl actuator
guide (809).
- Install the actuator guide assembly into the case.
- Align the slot for the actuator guide pin (808) in the park pawl
with the pin hole in the case.
- Use a mallet in order to install the actuator guide pin (808).
- Assemble the IMS (811) onto the park
pawl actuator assembly (800).
- Install the IMS detent lever assembly (811) and the park pawl
actuator assembly (800) into the case.
- Align the groove for the manual shift shaft
pin with the pin hole in the case.
- Use a mallet in order to install the manual shift shaft pin (801).