Tools Required
J 39529
Wiper Linkage Installer
Removal Procedure
- Position the wipers in the parked position.
- Disconnect the wiper motor electrical connector.
- Remove the wiper motor crank arm nut (4) and crank arm (5).
- Remove the wiper motor screws (3).
- Remove the wiper motor from the module assembly.
Installation Procedure
Important: A new wiper motor will be shipped in the parked position.
- Position the crank arm (5) to the wiper motor pivot shaft. Ensure the arm resides between the 2 casting dimples (2) as shown.
Notice: Refer to Fastener Notice in the Preface section.
- Install the crank arm pivot nut (4).
Tighten
Tighten the pivot nut to 10 N·m (89 lb in).
- Using the
J 39529
, secure the transmission link (1) to the wiper crank arm (5).
- Position the module assembly to the lower plenum. Refer to
Windshield Wiper System Module Replacement
.
- Connect the electrical connector (2) to the wiper motor (1).
- Reposition the wiper arms.
- Inspect the front wiper system operation.