The instrument panel cluster (IPC) illuminates the traction control indicator during the IPC bulb check. The body control module (BCM) supplies voltage to the traction control switch, when pressed the IPC receives a serial data message from BCM to illuminate the traction control indicator.

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Ignition ON, observe the traction control indicator to turn ON then OFF during the IPC bulb test.
2. With a scan tool command the IPC display test ON and OFF. The traction control indicator should turn ON and OFF.

⇒	If the traction control indicator does not turn ON and OFF, replace the IPC.

1. Ignition OFF, disconnect the harness connector at the traction control switch.
2. Test for less than 1 ohm between the ground terminal 1 and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify the scan tool BCM Traction Control Switch parameter is released.

⇒	If not the specified value, test the signal circuit terminal 4 for a short to ground. If the circuit tests normal, replace the BCM.

4. Install a 3A fused jumper wire between the signal circuit terminal 4 and the ground circuit terminal 1. Verify the scan tool Traction Control Switch parameter is pressed.

⇒	If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

5. If all circuits test normal, test or replace the traction control switch.

1. Ignition OFF, disconnect the harness connector at the traction control switch.
2. Test for infinite resistance between the signal terminal 4 and the ground terminal 1 with the switch in the open position.

⇒	If not the specified value, replace the traction control switch.

3. Test for less than 3 ohms between the signal terminal 4 and the ground terminal 1 with the switch in the closed position.

⇒	If greater than the specified range, replace the traction control switch.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.