GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1536799  Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel (I/P) right side endcap cover. Refer to Instrument Panel Outer Trim Cover Replacement .
  3. Remove the I/P compartment. Refer to Instrument Panel Compartment Replacement .
  4. Remove the 2 forward screws (1) securing the I/P accessory wiring junction block assembly to the I/P carrier.

  5. Object Number: 1536801  Size: SH
  6. Remove the 2 nuts (1) securing the I/P accessory wiring junction block assembly bracket (2) to the I/P carrier.

  7. Object Number: 1536802  Size: SH
  8. Lower the I/P electrical center bracket and swing the junction block into the stowage compartment area.
  9. Squeeze and release the retaining tabs from the shroud/base in order to release the electrical connector from the I/P wiring harness.
  10. Walk off the I/P accessory wiring junction block assembly from the connector.

  11. Object Number: 1536824  Size: SH

    Important: Re-stage the connectors (2) into the lower I/P accessory wiring junction block assembly base/shroud (1) prior to installing the new I/P wiring harness junction block.

  12. Ensure the main harness is secured into the lower shroud/base.

Installation Procedure

  1. Verify that the harness connectors are securely locked to the retention tabs (3).
  2. Position the connector (1) to the I/P wiring harness junction block.

  3. Object Number: 1536802  Size: SH
  4. Once the connector is aligned, carefully squeeze the connector to the base until both outer locking tabs are secure.
  5. Repeat step 3 for the additional connectors.

  6. Object Number: 1536801  Size: SH
  7. Position the I/P wiring harness junction block bracket (2) back to the I/P carrier bracket studs.
  8. Notice: Refer to Fastener Notice in the Preface section.

  9. Install the nuts (1).
  10. Tighten
    Tighten the nuts to 10 N·m (89 lb in).


    Object Number: 1536799  Size: SH
  11. Secure the 2 screws (1) at the I/P endcap.
  12. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  13. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
  14. Install the I/P right side end cap cover. Refer to Instrument Panel Outer Trim Cover Replacement .
  15. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  16. Perform the power sliding door re-initialization procedure. Refer to Rear Side Door Actuator Control Module Programming and Setup .