Temperature Valve Actuator Replacement Single Zone
Removal Procedure
- Remove the driver side knee bolster.
- Locate the air temperature actuator (6).
- Disconnect the air temperature actuator electrical connector (7).
- Remove the air temperature actuator bolts/screws (1).
- Remove the air temperature actuator (2).
- Remove the air temperature actuator lever (3), if necessary.
Installation Procedure
Important: The actuator lever can only be inserted into
the door one way.
- Install the air temperature actuator lever (3), if necessary.
- Install the air temperature actuator (2).
Notice: Refer to Fastener Notice in the Preface section.
- Install the air temperature actuator bolts/screws (1).
Tighten
Tighten the bolts/screws to 1.2 N·m
(11 lb in).
- Connect the air temperature actuator electrical connector
(7).
- Install the driver side knee bolster.
- Re-calibrate the actuators. Refer to
Actuator Recalibration .