• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
Stop Lamp Switch Signal | P0572 | P0572 | P0573 | -- |
The stop lamp switch signal circuit is a direct hard-wire input from the body control module (BCM) to the engine control module (ECM), and the transmission control module (TCM). The modules monitor the stop lamp switch signal circuit to detect when the brake pedal has been applied. The BCM monitors the brake apply sensor signal circuit to determine when the brake pedal is applied. When the brake pedal is applied, the BCM sends a serial data message to the modules and also a voltage signal on the stop lamp switch signal circuit indicating that the brake pedal has been applied.
• | The engine is running. |
• | Battery voltage is greater than 11.5 volts. |
The ECM detects a low voltage signal on the stop lamp switch signal circuit when the serial data message from the BCM indicates the brakes are applied.
The ECM detects a high voltage signal on the stop lamp switch signal circuit when the serial data message from the BCM indicates the brakes are not applied.
• | The malfunction indicator lamp (MIL) will not illuminate. |
• | The cruise control system is disabled. |
• | The condition responsible for setting the DTC no longer exists. |
• | A history DTC will clear after 40 malfunction-free ignition cycles have occurred. |
Cruise Control Description and Operation
Control Module References for scan tool information
With a scan tool, command the stop lamps ON and OFF. The stop lamps should turn ON and OFF when changing between the commanded states.
⇒ | If the stop lamps do not illuminate when commanded ON, refer to Stop Lamps Malfunction. |
• | ECM X1 |
• | TCM |
• | ECM terminal 7 |
• | TCM terminal 42 |
⇒ | If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM. |
⇒ | If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM. |
⇒ | If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the ECM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM or TCM replacement, setup, and programming